BEARING BUDDY - 1980

BEARING BUDDY - 1980
+ Tap or click image to enlarge
Bearing Buddy Bearing Protectors provide protection against damage from water and dirt entering the wheel bearings and make lubricating bearings a snap
$26.21 $36.95
SKU B-42102

Product Details

MODEL HUB BORE(mm) OUTER BEARING CONE OUTER BEARING CUP (race)
1980/1980A* 50.41 L-44643, L-44649, L-44640 L44610
1781 45.24 LM-11949 LM-11910
2328 59.25 LM-67048, hub not counterbored LM-67010
1810 45.97 LM-12749 LM-12711
1938 49.34 09067 09194, 95, 96
1968 50.08 M-12649, 07100 M-12610, 07196
1980T N/A All internally threaded hubs
2047 52.08 Various 07204
2080 52.92 900 series 900 series
2240 56.98 1700 series 1729
2441 62.08 LM-67048, hub counterbored, 15123 and others LM-67010, 15245
2562 65.07 48548 48510
2717 69.06 14124, 14125A 14276

Model #1980, for example, fits a 1.980'' bore hole diameter. Our 2080T (threaded model 2080) will fit the Reliable oil bath unit that is on many of the EZ Loader trailers.

Video

How To Use

BEARING AND SEAL INSPECTION
Remove hubs and check the bearings before installing Bearing Buddy®. Replace bearings if they are damaged, rusted, or pitted. Clean old grease and contaminants out of the hubs. Check the condition of the inner seals. Be sure they are new, top quality, and running on a smooth spindle sealing surface. IMPORTANT: As you reassemble the components, fill the hubs completely with a high quality, multipurpose, no.2 grade lubricant (e.g., the type used for automotive suspensions). Don't use heavy, fibrous greases; don't mix grease types.

BEARING BUDDY® INSTALLATION
Hold the Bearing Buddy® against the hub with a small block of wood, and drive it into place with a hammer. If Bearing Buddy® cannot be driven into the hub, or will not fit tightly into the hub, don't force it. Your hubs may be slightly oversized or undersized. If this occurs, or if the Bearing Buddy® is obviously too large or too small; contact your dealer. If you install Model 1980T (threaded), apply Permatex or some other grease proof gasket cement to the Bearing Buddy® threads, and then screw Bearing Buddy® into the hub, hand tight.

HOW TO REMOVE A BEARING BUDDY®
Bearing Buddy® is held in the hub by an interference fit. To remove Bearing Buddy®, lay a block of wood against the side of it and strike the wood with a hammer. Place the wood on the opposite side and hit again. Continue this procedure until you ''walk'' the Bearing Buddy® out of the hub. Don't disassemble the Bearing Buddy® to attempt to remove it.

Shipping

Warranty

More Information Visit Bearing Buddy

Additional items you might be interested in

PLASTIC FENDER - 7 x 20.5
PLASTIC FENDER - 7 x 20.5
$26.84 $103.95
SKU WB-8540
BACKING PLATE-3500 AXLE-10in EBLH-1000
BACKING PLATE-3500 AXLE-10in
$56.54 $69.18
SKU EBLH-1000